Cart
You have no items in your shopping cart
A 24cm workhorse with an ApexUltra blade and a desert ironwood handle. Read more..
This 24 cm workhorse has a very strong taper and a complex geometry. The blade is made with "Walkschliff". In the coil area, the blade has is strongly convex and the greatest blade thickness is about two-thirds the blade height. The convexity decreases further towards the tip and the largest blade thickness moves further towards the back of the blade. The tip is ground thin. As a result, the blade has very high cutting abilities in the front two-thirds and has a very strong wedge effect in the coil area.
The knife is equally suitable for all cutting techniques.
The cutting edge of this knife consists of the special melt ApexUltra with a hardness of approx. 66 hrc.
Of course, the blank was forged with optimal temperature control and forming and then subjected to extensive heat treatment (including deep-freeze treatment after hardening). This guarantees an optimally adjusted structure and extremely finely distributed carbides.
The handle is made of desert ironwood with a spacer made of reindeer horn and a bolster and decorative rivet made of wrought bronze. The decorative rivet is riveted to the tang.
Lenght of edge: |
240mm |
Max. height of the blade: |
57mm |
Thickness of the blade: |
|
Tang: |
7,7mm |
Coil: |
6,7mm |
Middle: |
2,9mm |
20mm before the tip: |
0,9mm |
Lenght of the handle: |
127mm |
Weight: |
343g |
Balancepoint: |
25mm before the handle |
Geometry: |
Workhorse |
Flatspot: |
no flatspot |
Core steel: |
C = 1,25 %
P <= 0,01 %
S <= 0,01 %
Si = 0,35 %
Mn = 0,30 %
Cr = 1,50 %
W = 2,60 %
V= 0,4%
66hrc
|
Intermediate layer: |
nickel |
Clad: |
1.2767 1.2842 1.2007 |
Material of the handle: |
Desert ironwood, reindeer antlers, bronze |
Shape of the handle: | western |